Promise Technology Ultra100 TX2 User Manual download pdf (Page 12)

Ultra100™ TX2 User Manual

Installing Driver in Existing Windows 2000 System

WARNING: If you will be moving the boot drive containing the existing

Windows 2000 operating system to the Ultra100 TX2 card, the Ultra100

TX2 driver MUST be loaded on to this hard drive while it is still attached

to your existing hard drive controller. Do not attach this drive or any

other hard drive to the Ultra100 TX2 controller card before completing this step.

After installing the Ultra100 TX2 card and rebooting your system, Windows 2000

setup will show a “New Hardware Found” dialog box. Under Windows 2000, “PCI

Mass Storage Controller” will be displayed.

1. Choose “Add New Hardware Wizard” from the list, and then press “Ente r”.

2. In the A:\ drive, insert the Ultra100 TX2 driver diskette.

3. Choose “SCSI Controller” from the hardware list that appears on screen.

4. In the “Install Drivers” dialog box, press “Have disk…”.

5. When the “Install From Disk” appears, insert the “Ultra100 TX2 Driver”

diskette in drive A:.

6. Type “A:\Win2000” in the text box. Press “Enter”.

7. Choose “Win2000 Promise Ultra100 TX2™ IDE Controller” from the list that

appears on screen, and then press the “Enter” key.

8. When the "System Settings Change" dialog box appears, remove the floppy

diskette and click on “Yes” to restart the system. Windows 2000 will then

restart for the driver installation to take effect.

Confirming Windows 2000 Installation

1. From Windows 2000, open the Control Panel from “My Computer” followed

by the System icon.

2. Choose the “Hardware” tab, and then click the “Device Manager” tab.

3. Click the “+” in front of “SCSI controllers.” Win2000 Promise Ultra100 TX2 ™

IDE Controller” should appear.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

No comments

Promise Technology Ultra100 TX2 User Manual Page 12