Promise Technology Ultra100 TX2 User Manual download pdf (Page 16)

Ultra100™ TX2 User Manual

Installing Drivers with Existing Windows 98

The following section details the installation of Ultra100 TX2 drivers on a system that

has Windows 98 already installed. If you’re installing the Ultra100 TX2 drivers on a

system during a Windows 98 installation, see “Installing Drivers During Windows 98

Installation.”

1. After installing the Ultra100 TX2 controller card and configuring the hard

drives, power up the system and boot Windows.

2. The “Add New Hardware Wizard” will appear, informing you that it has

found a “PCI Mass Storage Controller.”

3. Click on “Next,” and from the generated list box, choose “Search for a

better driver than the one your device is using now.”

4. Click on “Next,” and from the generated choices, choose “Specify a

location.”

5. Type “A:\WIN9X-ME” in the text box that appears.

6. Insert the “Ultra100 TX2 Driver” diskette in drive A:.

7. Click on “Next.” A message informing you that Windows has found “ Win9x-

ME Promise Ultra100 TX2™ IDE Controller” should appear.

8. Click on “Next,” and then on “Finish.”

9. Choose “Yes” when asked if you want to restart your computer. Be sure to

eject the diskette from drive A:.

Confirming Driver Installation in Windows 98

To confirm that the driver has been properly loaded in Windows 98, perform the

following steps:

1. Choose “Settings” from the “Start” menu.

2. Choose “Control Panel,” and then double -click on the “System” icon.

3. Choose the “Device Manager” tab, and then click the “+” in front of “SCSI

controllers.” “Win9x -ME Promise Ultra100 TX2™ IDE Controller” should

appear.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 38 39

No comments

Promise Technology Ultra100 TX2 User Manual Page 16