Promise Technology Ultra100 TX2 User Manual download pdf (Page 23)

Ultra100™ TX2 User Manual

Netware 4.11

NWPA Update Package Installation Instructions for NetWare 4.11

Before installing the Ultra100 TX2 NetWare driver, make sure that you have installed

the latest update for the NetWare 4 operating system.

1. From the website at http://developer.novell.com/devres/sas/certinfo.htm

download NWPA_UP.EXE from the "Download the Update Package" link.

2. Install DOS and the CD-ROM driver on the target server machine.

3. Create the directory C:\UPDATE, and then change to that directory.

4. Copy NWPA_UP.EXE to C:\UPDATE.

5. Execute NWPA_UP.EXE in the C:\UPDATE directory.

6. Delete NBI31X.NLM, NWTAPE.CDM, and NWTAPE.DDI.

For new NetWare 4.11 servers:

Note: If your server already has NetWare 4.11 installed, jump to step 7

of the next section "For Existing NetWare 4.11 Servers."

7. Change directory to the D:\ directory on the CD-ROM drive, if its drive letter

is D:

8. Enter install at the DOS command line. Proceed through the installation of

NetWare 4.11 as usual.

9. When prompted by Install to select a device driver to load, select the

ULTRA.HAM driver.

10. Switch to console mode by using <ALT><ESC> before continuing

installation, and type "load c:\update\IDEHD.CDM". Do this is to make sure

that the IDEHD.CDM is version 2.00 (1998-8-5) or newer. (The older default

IDEHD.CDM doesn't support LBA mode addressing, and will have problems

with the ULTRA.HAM driver.)

11. After IDEHD.CDM is loaded, use <ALT><ESC> to switch to the installation

monitor and proceed through the installation of NetWare 4.11 as usual.

When the installation program prompts you to edit STARTUP.NCF, enter the

following lines after any set parameters but before any file loading, then

save the file:

load c:\update\nwpa

load c:\update\nbi

load c:\update\idehd.cdm

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 38 39

No comments

Promise Technology Ultra100 TX2 User Manual Page 23