Chapter 9: Troubleshooting
191
Checking Enclosure Status in PASM
To check Enclosure status:
1. Start PASM.
See “PASM in your Browser” on page 123.
Or see “PASM in SmartNAVI” on page 125.
Or see “PASM in Bonjour” on page 127.
2. In the Tree, click the + beside the System icon.
3. Click the System Information icon.
4. Click the Enclosure Information tab.
See Figure 5.
Migration or Rebuilding
on array X paused at Y%.
RAID Volume Migration or Rebuild was paused
temporarily by user action.
Migration or Rebuilding
on array X resumed at
Y%.
RAID Volume Migration or Rebuild was paused and
then resumed by user action.
Migration or Rebuilding
on array X completed.
RAID Volume Migration or Rebuild has finished.
Normal.
Migration or Rebuilding
on array X aborted at Y%
RAID Volume Migration or Rebuild was aborted
(stopped) by user action.
Migration or Rebuilding
on array X aborted at Y%
because of error.
RAID Volume Migration or Rebuild has aborted
(stopped) because of an error. Check the disk drives.
See page 182. Check the RAID Volume. See
page 184.
RAID status: "OFFLINE".
The NS4600 X volume Y
is offline.
Check the disk drives. See page 182. Replace the
failed drive. See page 183. Create a new RAID
Volume. See page 148.
RAID status: "CRITICAL".
The NS4600 X volume Y
is not functioning
correctly.
Check the disk drives. See page 182. Replace the
failed drive. See page 183. The RAID Volume will
rebuild automatically.
RAID X had some errors.
Formatting was aborted!
Check the disk drives. See page 182. Replace the
failed drive. See page 183.
Reported Event Corrective Action
Comments to this Manuals